TECHNOZON HOME

Install TECHNOZON Home on TANIX W2

Check the firmware

In Android Settings, open About and check the model and build. This guide covers TANIX W2 with Amlogic S905W2, Android 11 and factory build 20230316.

Install from Windows

Download Windows Setup

  1. Start the W2 normally and connect it to Wi-Fi or Ethernet. Note its IPv4 address in Android network settings. In Developer options, enable USB debugging.
  2. Connect the OTG/device USB port on the W2 to a Windows 10 or 11 (x64) PC using a USB data cable. Approve USB debugging on the TV and leave the cable connected until Setup finishes.
  3. In Setup, enter the IP address shown in the network settings on the W2. Approve the connection on the TV if prompted and check that Setup identifies TANIX W2.
  4. Choose Install, follow the prompts, then press Home on the stock remote to open TECHNOZON Home.

On the W2, Setup grants Android usage access. After a restart, Home checks locally which app is on screen so it can replace Oranth if the firmware opens it. Restoring the factory launcher returns this permission to its previous setting.

Remotes

Use the original remote for normal navigation. To assign buttons on a compatible additional USB or Bluetooth remote, connect it and open Remote buttons in TECHNOZON Home settings.

Restore the factory launcher

Reconnect the same W2 to the PC by USB, enter its current IP address in Windows Setup and choose Restore stock HOME. When Setup finishes, press Home on the remote to open the factory Oranth launcher.